Clock Repair in The Colony, TX
Lakeside humidity swings are hard on wooden cases and cause chime rattles. We adjust hammers and stabilize cases so the strike stays clean.
How we work in The Colony
- Case and veneer stabilization after humidity damage
- Hammer and chime rod adjustment
- Weight cable and pulley replacement
Clocks under about four feet are usually best brought to our Denton bench, where we can test-run them properly. Anything taller — grandfather, longcase, tall regulator — we handle in the home or collect ourselves, with the pendulum, weights and chime rods secured before the case is moved.
ZIP codes covered
75056 and immediately surrounding addresses. Nearby communities are covered on the same routes; call if you are just outside these codes.
Services available in The Colony
The Colony appointments
Same-week scheduling is typical. Free phone estimates.
1004 N Austin St, Denton, TX 76201
(214) 779-9792
What The Colony customers ask
Do you make house calls?
Yes. Grandfather and other tall-case clocks are usually serviced in the home or collected by us. We cover Denton, Denton County and surrounding North Texas communities.
How long does a repair take?
Two to four weeks is typical for a full overhaul, because the movement runs on test for one to two weeks after reassembly before it is regulated and released. Small adjustments are often same-week.
How much does clock repair cost?
Most work is quoted after inspection because the movement, not the case, determines the labor. A cleaning and oiling on a simple time-only movement is the low end; a triple-chime grandfather movement needing bushings sits considerably higher. You get a written estimate before we begin and a phone call before any additional work.
Nearby towns we serve
Clock trouble in The Colony?
Call (214) 779-9792 and describe what it is doing. Most problems are diagnosed over the phone.